UNIVERSAL FUEL FILTER WATER SEPARATOR SYSTEM
R1,215
No matter how carefully gasoline or diesel is handled, contamination in the form of dirt, sludge or water will always find its way into your marine vessel’s fuel tank. With modern engines now injecting fuel at over 36,000 psi (2,500 bar) and injector tolerances measured in microns, even a small amount of dirt or water corrosion can cause damaged components, reduced engine efficiency, and in severe cases, complete injector break-down. *N*
- Description
- SPECIFICATIONS
- in the box
- Shipping
Description
The o-ring does not compress and allows the filter to touch the housing, which then creates a leak. The O-rings are of excellent quality.
VITON SEALS
10 MICRON FILTER MEDIA
Thread Type / Size: Mercury Thread 11/16″ 16 T.P.I
Included: Brass head with fittings
Interchangeable With:
MERC 35-60494-1 – UNIVERSAL
Draining of water or replacement of elements is determined by the contamination level of fuel. Inspect the collection bowl for water daily and service as necessary. Replace the element at least once a year or when a decrease in power is noticed.
To Drain Water:
1. Loosen a self-venting drain plug to drain water from the bowl into a container.
2. Tighten the drain.
3. Use a primer bulb to fill the filter with fuel.
4. Start the engine and check to ensure there are no leaks.
To Replace Element:
1. Loosen the self-venting drain plug and drain the element into a container.
2. Remove filter element from mounting bracket with bowl connected.
3. Remove the bowl from the filter element and clean the o-ring gland on the bowl. BOWL IS REUSABLE * DO NOT DISCARD IT.
4. Lubricate the o-ring with oil or grease and install it on the bowl.
5. Install the bowl onto the new element, and tighten it by hand.
6. Lubricate filter top seal with oil or grease.
7. Fill filter/bowl assemble with clean fuel and attach onto mounting bracket, tighten by hand.
8. Start the engine and check to ensure there are no leaks.
Series Type: Marine Spin-on FF/WS
Series: Gasoline Spin-on
Mounting: Bracket Included
Pressure Drop (psi): 0.6
Pressure Drop (bar): 0.04
Replacement Element: S3227 = 10 Micron / S3228SUL = 2 micron
Element Type: 10 Micron Aquabloc Spin-on
Height: 9.4 in / 23.9 cm
Width: 4.0 in / 10.2 cm
Depth: 4.0 in / 10.2 cm
Weight: 2.0 lb / 0.5 Kg
Maximum Working Pressure (psi): 7
Maximum Working Pressure (bar): 0.5
Material: Powder Coated Aluminium Alloy
Number of Ports: 3
Water Sensor Option: None
Fuel Filter Water Separator x 1
Brass Fittings x 4
Additional information
| Weight | 2 kg |
|---|---|
| Dimensions | 25 × 12 × 12 cm |
