HYDRAULIC POWER LIFT K CMC 5 1/2”
R38,995
CMC, PL-65 Hydraulic Jack Plate, 5 1/2″, without gauge. The PL-65 is rated for V-6 motors and smaller and gives you 5″ of vertical travel with 1-1/2″ of adjustment on the motor bracket and 1-1/2″ of adjustment on the transom bracket. A total of 8″ of possible adjustment. *D*
- Description
- in the box
Description
The dependable, self-contained and waterproof hydraulic actuator has a maximum lifting capacity of 3570 kg of thrust. More than any other transom jack. You will have no problem lifting even a V-6 300HP motor at full throttle.
The hydraulic actuator is mounted inside the structure of the Power-Lift, yet it is fully accessible without removing the engine. There are no hoses to contain, nor will you have to contend with mounting a pump and reservoir inside your boat, as is the need with other transom jacks. The hydraulic actuator is completely self-contained with its own fluid reservoir (eliminates the need for a hydraulic tank and hoses inside the boat). It contains a permanent magnet motor for more power and constant torque. The cylinder within the actuator has twice the lifting capacity of other transom jacks on the market. It contains a no-leak seal and wiper that keeps dirt and water out of the working parts. The system is made of 100% non-ferrous material which makes it impervious to saltwater and freshwater.
The patented roller design means less friction, longer wear, less maintenance, and virtually no binding problems which are common with other transom jacks. The roller assembly contains a stainless steel 3/4″ pin with aluminium-bronze alloy rollers. The roller is highly impact-resistant, corrosive resistant, and has a high load-carrying capacity. This patented design virtually eliminates any chance of binding which is common with other transom jacks.
Features:
– Full stroke in 8 seconds
– Features Of Patented Hydraulic Power-Lift® (U.S. Patent 4,482,330)
– Made of 6061 T6 alloy aluminium extrusions and fastened with stainless steel fasteners
– Ideal for fresh or saltwater use
– No welds or castings to break
– Designed to offer exceptional performance and reliability
– Made using high-quality materials for long-lasting service life
– Proven to live up to the most demanding marine conditions
– Engineered to meet or exceed the highest quality standards
Hydraulic Power-Lift unit x 1
Wire assembly x 1
1/2″ -13 x 3 stainless steel hex head cap screws x 4
1/2″ -13 stainless steel hex nuts x 4
1/2″ stainless steel lock washers x 4
1/2″ stainless steel flat washers x 4
Up down toggle switch x 1